Drilling Front Fenders and Rocker Panels

TB 43-0213

d. Drilling Front Fenders and Rocker Panels (see

Figure 5-4). Drill four holes on each side. Holes A and

B may be sight drilled. Hole C is drilled below the

center of the fender support. Hole D can be sight

drilled inside the fender well.

TA504795

Figure 5-6. Drilling Front Cargo Bed.

g. Drilling Rear of Doors (see Figure 5-7). Drill

two holes A and B in each door. Holes are sight drilled.

TA504793

Figure 5-4. Drilling Front Fenders and

Rocker Panels.

e. Drilling Taillight Opening (see Figure 5-5). Drill

one hole A in each taillight opening. Holes are sight

drilled.

TA504794

Figure 5-5. Drilling Taillight Opening.

f. Drilling Front Cargo Bed (see Figure 5-6). Drill

five holes in front of the cargo bed, Hole C is drilled

first at the center of the bed. The remaining four holes

are then spaced approximately 12 inches (30.5 cm)

TA504796

Figure 5-7. Drilling Rear of Doors.

apart.

5-3