Section II. DRILLING AND CLEANING PROCEDURES

TB 43-0213

Section Il. DRILLING AND CLEANING PROCEDURES

Drilling Procedures.

5-2.

NOTE

Unless otherwise indicated, all holes

drilled should be sight drilled and should

be 1/2 inch (1.3 cm) in diameter.

Drill holes at approximate locations indi-

cated by the black dots.

a. General. Refer to paragraph 3-15 for general

drilling instructions.

b. Drilling Inner Hood Panel (see Figure 5-2). On

older models, drill 19 holes in the inner hood panel

support. Later models will have existing holes which are

located at points D, K, L, and R.

c. Drilling Cowl (see Figure 5-3), Drill 11 holes in

cowl. Holes A and B should be 5 inches (12.7 cm)

TA504791

from the inside of fenders. Hole F should be 6 inches

Figure 5-2. Drilling Inner Hood Panel.

(15.2 cm) from the inside of the fender. All other holes

are sight drilled.

TA504792

Figure 5-3. Drilling Cowl.

5-2