Figure 17

MWO 9-2330-392-20-2

WARNING

When installing breakaway lever spring onto breakaway lever and

actuator housing you must hold the spring in place until master cylinder

is installed. If the spring is not physically held in place as defined, it

can fall out of the actuator housing, resulting in no surge brake

protection for the trailer.

11. Reinstall breakaway lever spring (10) (see Figure 17) between master cylinder and

breakaway lever. Reinstall master cylinder, torque cap screws to 30 ± 3 ft·lb (see Figure

2). Ensure correct operation of breakaway system (see Figure 17).

12. Install landing leg pivot, use one new lock washer with existing screw and two new

locking hex nuts with existing flat washers and existing bolts. Torque screw to 210 ± 20

ft·lb and locking hex nuts to 150 ± 10 ft·lb (see Figure 4).

Figure 17

13. Install leveling jack and secure with quick-release pin (see Figure 3).