RECORDING AND REPORTING OF THE MODIFICATION.

MWO 9-2330-392-20-2

b. Installer Responsibilities. The installer is responsible for following

instructions in MWO 9-2330-392-20-2. Requirements contained in this

MWO shall be included in the installers inspection plan or quality assurance

program. These requirements shall not be construed as eliminating the

installer's responsibility from complete compliance with the provisions of the

contract and submitting to the Government products that meet all

requirements of the contract.

c. Government Verification. All QA operations and installation changes and

inspections performed by the installer are subject to Government verification

at unannounced and varying intervals. Verification will consist of

observations and inspections to confirm that practices, methods and

procedures of the installers written inspection plan are being property applied;

and that government product inspection to confirm quality of product offered

for Government acceptance does not deviate from prescribed acceptance

standards specified in MWO 9-2330-392-20-2 as well as TM 9-2330-392-

14&P. Deviations will be brought to the attention of the installer for

correction.

d. In-process Inspection. During normal assembly operations, paragraph 10,

Modification procedure, will be used to check the installer's work. After

installation is complete, the vehicle will be checked IAW TM 9-2330-392-

14&P PMCS (Table 2-1, checklist) for correct installation and to ensure there

are no vehicle defects. Any defects noted will be corrected by installer before

the vehicle is placed in service. All vehicles modified during a productions

shift will be checked to ensure product quality.

14.

RECORDING AND REPORTING OF THE MODIFICATION.

a. Records and Reports. The organization responsible for MWO application will

report application information as follows:

(1) Reporting will be accomplished by electronic means. MWO application

information will be input directly into the Modification Management

Information System (MMIS) over the internet. If the internet is not available,

recording will be on a 3.5 inch disk, which will be mailed to TACOM, MMIS

administrator. Entry into MMIS system is password protected. New users

can register online at www.mmis-mwo.com. Passwords are normally

approved and issued within 48 hours.

(2) Submission will be comprised of the nine (9) data elements listed in the table

below. Elements 1,2,4,6,7,8 &9 are given for this MWO (as shown). The

person reporting the MWO data will acquire the remaining elements (3&5)

and input all nine into the MMIS.