Figure 10

MWO 9-2330-392-20-2

NOTE

Ensure that the drill motor is relatively perpendicular to the top

plate so that the drill bit will enlarge both the top and bottom

rivet holes in a straight, perpendicular line. Take care not to bend

drill bit.

7. Using a (27/64) drill bit, enlarge each of the rivet holes (see Figure 10) by drilling

from the top all the way through the bottom rivet hole (see Figure 11).

Figure 10

Figure 11

8. Using the (27/64) drill bit, enlarge each of the six rivet holes in the landing leg

mounting bracket. Bracket can be held in a vise and drilled either from the top or the side.

Make sure drill is perpendicular to bracket (see Figure 12 & 13). If available, a drill

press should be used.

Figure 12

Figure 13