ASSEMBLY-continued

TM 9-2350-222-34-1

AIR CLEANER FAN REPAIR (Sheet 7 of 11)

3. Aline marks on front end head (A) with alinement

marks on motor housing (E).

4. Using fingers, push end of power cable lead (F)

from motor housing (E) thru opening in front end

head (A) as shown.

5. Turn fan over and using fingers pull brush ground

lead (G) thru opening in front end head (A) as

shown.

6. Using 3/8 inch screwdriver, install and tighten

two lockwashers (H) and screws (J) thru motor

housing (E) into front end head (A).

7. Install brushes (K) by pulling out on long arm of

spring with needle norse pliers and holding aside

while brush is inserted.

8. Position springs (C) over end of brushes (K).

Go on to Sheet 8

TA130472

4-8