Section VIII. ELECTRONIC MODULE ASSEMBLY (Al2A4)

TM 3-6665-302-34

(7) Install knobs, boots and plunger (para

(14) Remove heater assembly (para 3-

4-48 b).

52a).

(15) Remove housing assembly and boot

(8) Install i d e n t i f i c a t i o n plate (para 3-

(para 3-53a).

47 b).

(16) Remove horn and gasket (para 3-

(9) Install meter and gasket (para 3-46b).

54a).

(10) Install connector cover (para 3-45b).

b. Reassembly.

(11) Install p r e s s u r e r i n g ( p a r a 3 - 2 2 b ) .

(1) Install horn and gasket in top subas-

sembly (para 3-54b).

(12) Install air inlet heater assembly (para

(2) Install housing assembly and boot (para

3-21 b).

3-53b).

(13) Install air inlet assembly (para 3-20b).

(3) Install heater assembly (para 3-52 b).

(4) Install 24 VDC INPUT connector and

(14) Install air filter plug and preformed

gasket (para 35lb).

packing (para 3-29b ).

(5) Install thermostatic switch (para 3-

(15) Install handle (para 3-16 b).

50 b).

(16) Install chassis assembly in case top as-

(6) Install REMOTE binding posts (para

3-49 b).

sembly (para 3-27 a through f).

Section VIII. ELECTRONIC MODULE ASSEMBLY (Al2A4)

3-56. General

3-58. Reassembly

Direct support maintenance personnel are au-

a. Place shim (3) on fastener stud (4).

thorized to repair the electronic module assembly

b. Center pin through tip of fastener stud (4).

by replacing the turnlock fastener.

c. Position fastener stud (4) as shown in fig-

3-57. Disassembly

ure 3-23 and slide it through holes in module

(fig. 3-23)

(5).

a. Remove electronic module assembly (TM

d. Attach retaining ring (2).

3-6665-225-12).

b. Remove retaining ring (2).

e. Test electronic module assembly (para 3-

5g).

C. Slide fastener stud (4), shim (3), and pin

(1) from module (5).

f. Install electronic module assembly in case

d. Remove shim (3) and pin (1).

top assembly (TM 3-6665-225-12).

3-26