Brake Stall Test Tool-continued

TB 9-2350-368-25

13. Drill 3/8-inch pivot hole on the 9-inch side of 1/4-inch steel angle (1). See Figure 2-28.

14. Measure 5/8 inch and scribe a line on two 1/4-inch steel plates (5), centered.

15. Scribe three lines 1/2 inch, 1-1/2 inch, and 3/4 inch from end of 1/4-inch steel plate (5). See Figure 2-28.

16. Drill 3/8-inch hole where first line intersect and two 1/2-inch holes where the remaining two lines

intersect in two 1/4-inch steel plates (5). See Figure 2-28.

17. Cut rubber hose (6) approximately 8 inches to be used as a handle for steel plate (3). See Figure 2-28.

18. Align holes in the angle (1) and adjusting plate (4) weld plate (4) to angle (1). Insert handle (3) between

plates (4) and angle (1) secure with one screw (13), two washers (10), roll spacer (7), and nut (11). Attach

rod-end clevis (12), screw (13), two washers (10), and nut (11) to handle (3). Attach two plates (5) to rod-

end clevis connector (12) with one screw (13), two washers (10), and nut (11). Push rubber hose (6) onto

handle (3).

2-47