 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
  TB 9-2350-368-25
b. Brake Stall Test Tool
Bill Of Materials
Item
Nomenclature
Part Number
NSN
Qty
2" by 3" by 1/4" Steel Angle
1
10 inches (25.4 cm)
1
2
4 inches (10.2 cm)
1
1/4" Steel Plate
3
20 by 1 inch (50.8 by 2.5 cm)
1
4
1/4 by 3-1/4 inches (6.4 by 83 mm)
2
1/8" Steel Plate
5
6 by 1/8 inches (152 by 3.2 mm)
1
Rubber Hose
6
8 by 1 inch ID (20.3 by 2.5 cm)
1
7/16" ID Roll Steel
7
2 inches (5.1 cm)
1
Hardware/Components
8
Quick Release Pin
MS17984
1
9
Chain
1
10
Washer
MS27183-283
6
11
Nut
MS51922-18
3
12
Clevis Rod End Connector
MS35812-2
1
13
Screw
B1821BH038C300N
3
14
Screw
24617-9425094
2
15
Washer
23018199
5310-01-216-1367
2
1. Measure 9 inches on one side of steel angle (1) and 10 inches on the other side. Scribe a line joining the
marks.
2. Cut steel angle (1) at approximately 60° along scribed lines.
3. Measure 3 inches on one side of steel angle (2) and 4 inches on the other side. See Figure 2-28. Scribe a
line joining the marks.
4. Cut steel angle (2) at approximately 60° along scribed lines.
5. Weld steel angles (1) and (2) along 60° angle. See Figure 2-28.
6. Scribe a line one inch from end of 1/4-inch steel plate (3) and four inches from the one inch scribe line.
Scribe a line centered lengthwise (1/2 inch from edge). See Figure 2-28.
7. Drill two 3/8-inch diameter holes where scribe lines intersect.
8. Measure down the middle of 1/8-inch plate (4) and scribe a line.
9. Starting about 3/4-inch from end of 1/8-inch steel plate (4), scribe ten lines evenly spaced (approximately
every 29/64).
10. Drill ten 1/4-inch holes where scribe lines intersect. See Figure 2-28.
11. Bend 1/4 inch on both ends of 1/8-inch steel plate (4) approximately 90°.
12. Using 1/8-inch plate (4) as template, drill ten 1/4-inch holes in 1/4-inch steel angle (1).
2-46
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals