Counterbalance Cable Removal.

TM 55-4920-438-13&P

d. Counterbalance Cable Removal.

After shop erection is complete (AND

COUNTERBALANCE CABLES ARE SECURED), remove three

screws (1) from cable retainer block (2).

2. Let cable (3) and retainer block (2) hang loose

next to shelter (4).

3. Reinstall retainer block screws

(1) and secure.

e. Shop is now ready for reconfiguration of equipment to operational mode.

NOTE

All equipment and tools secured to floor or walls of the shelter must be carefully tightened to

specific torque limits. See Appendix F.

SECTION II. PREPARING SHOP FOR OPERATION

2-2. ECU Shelves, lowering procedures.

NOTE

The following procedures apply only if the ECU are

to be installed.

NOTE

(For shelter PN 136-0000-101) One ECU opening is

located in the fold-out end wall and one ECU opening

is located in the fold-out side wall

(For shelter P/N 5-4-2828-1) Both ECU openings are

located in the fold-out end walls. One ECU opening

in each fold-out end wall.

a. Remove four plugs (1) on outside of each shelf (2).

Change 1 2-3