Figure 2-2. Tube locations, Spectrum Analyzer TS-729(*)/U.

TM 11-6625-255-14/TO 33A1-13-170-1

leads to the METER binding posts.

nector, plug type UP-121M, or equivalent as needed.

(4) If an oscilloscope is to be used, connect it to

In all other models the power cord is terminated with

the OSCILLOSCOPE binding posts.

connector plug UP 121M.

(3) If the AC outlet is of the standard two-slot

2-6. Installation of Plug-in Items

type, use a standard plug, and ground the equipment

The TS-723(*)/U is shipped with the tubes and fuses

with No. 12 AWG copper wire, or equivalent.

installed.

b. Make the input and output connections as

a. Check for breakage and proper seating of tubes

follows:

(1) For distortion measurements, connect the

b. Check that proper fuses are installed in fuse

test leads to the AF INPUT binding posts.

holders.

(2) For noise, signal level, or gain measurements

(1) 1.6A, 250V fuse in 1.6 AMP fuse holder (0.8A,

which require preamplification, connect the test leads

250V for 230V operation).

to the AF INPUT binding posts.

(2) 0.15A, 250 fuse in .15 AMP fuse holder.

(3) For noise, signal level, or gain measurements

that do not require preamplification, connect the test

Figure 2-2. Tube locations, Spectrum Analyzer

TS-729(*)/U.

2-3/( 2-4 blank)

Change 1