TM 9-2330-285-14&P/TO 36A11-21-10-1
REAR HARNESS AND RECEPTACLE - EARLY MODELS
This task covers:
INITIAL SETUP
Tools
Applicable Configurations
Early models
Cross-tip screwdriver
7/16-inch wrench (two required)
ACTION
ITEM
REMARKS
LOCATION
REMOVAL
NOTE
Make sure that the rear harness and the light harness leads
are properly identified before unplugging the connectors.
1 Rear axle
Four terminal
a. Snap harness terminals (2) out of
clips (l).
clips (1) and
nine harness
b. Disconnect all lights from rear harness
terminals (2)
(3) at the terminals (2).
Take off using two 7/16-inch wrenches.
Cover (4), four
2
nuts (5), four
screws (6), four
washers (7) and
receptacle (8)
3
Take off using a cross-tip screwdriver.
Six clamps (9),
Remove the harness (3) from the axle.
six screws (10)
and six
washers (11)
INSTALLATION
4 Rear axle
Position on the axle.
Rear harness (3)
Six clamps (9),
Secure rear harness (3) to the axle using a
5
six screws (10)
cross-tip screwdriver.
and six
washers (11)