Figure 4. Radio bearing pointer test setup.

Figure 4. Radio bearing pointer test setup.

b. Set primary power S1 to ON.

tings listed in table 5. In each case, XMTR 2 will indicate

c. Adjust XMTR 1 to set the heading dial to N.

as shown.

g. Set XMTR 2 to 180°.

d. Adjust XMTR 2 to set the RBP to the heading dial S

h. Set primary power S1 to OFF.

mark. XMTR 2 will indicate 0° ± 1°, 15 minutes.

e. Adjust XMTR 2 for an increasing heading. The RBP

i. Set XMTR 2 to 10°.

j. Set primary power S1 to ON. The time required for

will rotate in the direction of increasing heading.

the RBP to come to rest at 190° as measured with stop-

f. Adjust XMTR 2 to set the RBP to each of the set-