|
| |
Back
Figure 2-8. Starting the Generator Set (Sheet 3 of 3) | Up
TM-9-6115-464-12 Wrench Impact Hydraulic Model MV-12-140T Manual | Next
PARALLEL OPERATION (LOAD TRANSFER). |
ARMY TM 9-6115-464-12
AIR FORCE TO 35C2-3-445-1
NAVY NAVFAC P-8-624-12
Step 1. PLACE THE CIRCUIT BREAKER SWITCH IN THE OPEN POSITION.
Step 2. ALLOW THE GENERATOR SET TO OPERATE APPROXIMATELY THREE TO FIVE MINUTES
WITH NO LOAD APPLIED WHILE OPERATING AT GOVERNED SPEED AND RATED HERTZ (DO
NOT READJUST FREQUENCY ADJUST RHEOSTAT OR PUSH IN THE MANUAL SPEED CON-
TROL PRIOR TO SHUTDOWN).
Step 3. PLACE THE START-RUN-STOP SWITCH IN THE STOP POSITION.
Step 4. OPEN THE DC CONTROL CIRCUIT BREAKER.
Figure 2-9. Stopping the Generator Set
2-19
|
