TM 9-2350-222-20-1-4
SHIFTING CONTROL BRACKET AND CONNECTING LINK ASSEMBLY REPAIR AND
REPLACEMENT (Sheet 8 of 9)
9.
Using 9/16 inch socket, install two bolts (M)
through link assemblies (K) and (L) and stud
and rod end bearing assembly (J).
10. Using torque wrench and 9/16 inch socket,
tighten two bolts (M) to 15-20 lb-ft (20-27
Nm).
INSTALLATION:
1.
Position bracket assembly (A) and shield (B)
against hull wall with mounting holes alined.
2.
Using 9/16 inch socket and 9/16 inch wrench,
(D) through bracket (A).
3.
Using torque wrench, extension, and 9/16
inch socket, tighten three screws (D) to 15-20
lb-ft (20-27 N.m).
4.
Position rod end (E) in clevis (F).
5.
Using 9/16 inch wrench, install bolt (G)
through clevis (F) and rod end (E).
6.
Using torque wrench and 9/16 inch socket,
tighten bolt (G) to 15-20 lb ft (20-27 N.m).
7.
Install shield (H) over shield (B) with holes
alined.
Go to Sheet 9
Change 1 11-59