TM 9-2350-222-20-1-4
SHIFTING CONTROL BRACKET AND CONNECTING LINK ASSEMBLY REPAIR AND
REPLACEMENT
Position seal assembly (J) over shield (H)
8.
with holes alined.
Position two flat washers (K) on seal
9.
assembly with holes alined.
Using 7/16 inch socket, install five new
10.
assembly (J) and shield (H) to shield (B).
11.
Using 7/16 inch socket, install four new
12.
spacer (P) and gasket (N).
Lubricate connecting link at grease fitting (S)
13.
using grease (Item 36, Appendix D).
Position clamp (T) on cable (U)>
14.
Position cable (U) and clamp (T) on hull wall.
15.
Using 7/16 inch wrench, install screw (V)
16.
through clamp (T).
Insert shaft assembly (W) into link assembly.
17.
18.
Check shifting pattern response (TM
19.
9-2350-222-10). If trasmission does not shift
End of Task