TM 9-2350-222-20-1-4
SHIFTING CONTROL BRACKET AND CONNECTING LINK ASSEMBLY REPAIR
AND
REPLACEMENT
(Sheet 6 of 9)
14. Place bracket (Q) into vise.
-
15.
Using 5/16 inch wrench, remove grease fitting
(R).
16. Inspect grease fitting (R) for blockage or
damaged threads. Throw away if damaged.
17. Using hammer, 1/8 inch punch, and welding
rod, remove pin (S), Throw pin away.
18. Using hammer and 1/2 inch punch, remove
shaft (T).
19. Remove connecting link (U) and two washers
(v).
20. Inspect washers (V) and connecting link
bearings (W).
NOTE
perform steps 21 and 22.
21,
Using 1/2 inch punch and hammer, remove
bearings (W). Throw bearings away.
22.
Using vise, press new bearings (W) one at a
time into connecting link (U), flush with outer
surface of connecting link (U).
GO on to Sheet 7
TA139310
11-57