INSTALLATION-continued

TM 9-2350-222-20-1-4

GENERATOR REPLACEMENT (Sheet 15 of 15)

Using 9/16 inch wrench, install new lockwasher (AU), ground strap (V), flat washer (AV), and new

30.

self-locking nut (AW) to terminal (AX).

Using 9/16 inch wrench, install electrical lead (circuit 530), electrical lead (circuit 415), electrical

31.

lead (circuit 2), flat washer (AY) and new self-locking nut (AZ) to terminal (BA).

Using 3/8 inch wrench, install electrical lead (circuit 1), flat washer (BB) and new self-locking nut

32.

(BC) to terminal (AS).

Using 3/8 inch wrench, install electrical lead (circuit 478), flat washer (BD), and new self-locking

33.

nut (BE) to terminal (AT).

Connect engine for powerplant test run ground hop (page 5-48).

34.

35.

Start and run engine at idle speed according to procedures for powerplant test run (page 5-52).

36.

Check BATTERY-GENERATOR indicator in driver's compartment for proper indication.

Shut down and disconnect engine as prepared for powerplant test run (ground hop) (page 5-62).

37.

38.

Install 2A powerplant (page 5-14) or 2D powerplant (5-37).

End of Task

TA139573

10-18