MARKINGS ON CAMOUFLAGED EQUIPMENT

TM 43-0139 b. Inspection Requirements. Every pattern applied using the projection method must be fully inspected in accordance with Section III, Inspection Procedures. No random sampling is permitted. 4-8. MANUAL METHOD The manual application of color boundary lines is considered to be the least accurate and least repeatable method of CPP application. This method uses a modified "free-hand" approach for applying the color boundaries with the aid of various pattern point guideline techniques such as grid layout, transfer of scaled points from CPP drawings, etc. a. Degree of Accuracy/Consistency. The manual method is the least accurate, least repeatable application method. Therefore, its use is greatly discouraged. It is considered a last resort' method. b. Inspection Requirements. Every pattern applied using the manual method must be fully inspected in accordance with Section III, Inspection Procedures. No random sampling is permitted. 4-9. MARKINGS ON CAMOUFLAGED EQUIPMENT After the equipment has been pattern painted, only the following markings are to be applied: NOTE Markings on CARC camouflaged equipment will be CARC in colors designated in figure 4-2. a. Unit Identification. Type and location remain the same. b. National Symbol. Paint a 3-inch star on both front and rear. Symbol should be centered on the equipment, on line with unit ID markings. On the rear of wheeled vehicles, the star may be placed on the tailgate. c. Agency Identification and Registration Number. The identification and registration number shall be placed on any appropriate interior area, if available, which is visible from outside a locked or secured item. d. Safety and Instructional Markings. Markings such as tire pressure, fuel type, and fill level will be in letters no larger than one inch. Markings directly related to troop safety, such as wrecker boom capacity and danger zones, must be evaluated by safety personnel. e. CARC Markings. Equipment with data plates shall have the word "CARC" painted in a conspicuous area as near the data plate as possible. Painting shall be in block letters, as large as possible, not to exceed one inch. All major items having a log book shall have the Equipment Control Record, DA Form 2408-9, annotated in the lower left corner of Block 21, Remarks, reflecting the word "CARC", and the date applied. Change 2 4-5