|
| |
Back
MARKINGS ON CAMOUFLAGED EQUIPMENT | Up
TM-43-0139 Painting Instructions for Army Material Manual | Next
LEVEL I INSPECTION |
TM 43-0139
Figure 4-2. Markings on Camouflaged Equipment.
Section III. INSPECTION PROCEDURES
4-10. GENERAL
The full CPP inspection consists of three levels of inspection: Level I, Level II, and Level III. Level I is essentially a visual
conformance check from 50 feet or more. Level II is a close-up boundary inspection using a CPP overspray gauge. Level
III is a detailed comparison of actual physical measurements to nominal dimensions.
4-11. MATERIALS/TOOLS REQUIRED
After becoming completely familiar with the inspection procedures outlined below, the inspector should assemble the
following materials/tools:
· CPP designs, including inspection worksheet (para 4-3) and overspray gauge (fig 4-3)
· One (1) 6-foot steel measuring tape, graduated in sixteenths (or thirty-seconds) of an inch
· One (1) 6-foot steel measuring tape, graduated in tenths of an inch
· Small T-square and/or straight edge
· Soapstone or chalk
· Pen, pencils, colored pencils
· Paper/notebook
· One plumb bob, with string
4-6
|
