Roller Bandage
The roller bandage, shown in figure 3-2, consists of a long strip of material (usually gauze, muslin, or elastic) that is wound into a cylindrical shape. Roller bandages come in various widths and lengths. Most of the roller bandages in the first aid kits have been sterilized, so pieces may be cut off and used as compresses in direct contact with wounds. If you use a piece of roller bandage in this manner, you must be careful not to touch it with your hands or with any other unsterile object.

GENERAL APPLICATION.-In applying a roller bandage, hold the roll in the right hand so that the loose end is on the bottom; the outside surface of the loose or initial end is next applied to and held on the body part by the left hand. The roll is then passed around the body part by the right hand, which controls the tension and application of the bandage. Two or three of the initial turns of a roller bandage should overlie each other to properly secure the bandage (see figure 3-3).

In applying the turns of the bandage, it is often necessary to transfer the roll from one hand to the

Table 3-2.-Ambulance Emergency Bag Contents

Table 3-3.-Unit One Bag Contents

Figure 3-1.-Commonly used styles of dressings.

other. Bandages should be applied evenly, firmly, but not too tightly. Excessive pressure may cause interference with the circulation and may lead to disastrous consequences. In bandaging an extremity, it is advisable to leave the fingers or toes exposed so the circulation of these parts may be readily observed. It is likewise safer to apply a large number of turns of a bandage, rather than to depend upon a few turns applied too firmly to secure a compress.

In applying a wet bandage, or one that may become wet, you must allow for shrinkage. The turns of a bandage should completely cover the skin, as any uncovered areas of skin may become pinched between the turns, with resulting discomfort. In bandaging any extremity, it is advisable to include the whole member (arm or leg, excepting the fingers or toes) so that uniform pressure may be maintained throughout. It is also desirable in bandaging a limb that the part is placed in the position it will occupy when the dressing is finally completed, as variations in the flexion and extension of the part will cause changes in the pressure of certain parts of the bandage.

The initial turns of a bandage on an extremity (including spica bandages of the hip and shoulder) should be applied securely, and, when possible, around the part of the limb that has the smallest circumference. Thus, in bandaging the arm or hand, the initial turns are usually applied around the wrist, and in bandaging the leg or foot, the initial turns are applied immediately above the ankle.

The final turns of a completed bandage are usually secured in the same manner as the initial turns, by employing two or more overlying circular turns. As both edges of the final circular turns are exposed, they should be folded under to present a neat, cufflike appearance. The terminal end of the completed bandage is turned under and secured to the final turns by either a safety pin or adhesive tape. When these are not available, the end of the bandage may be split lengthwise for several inches, and the two resulting tails may be secured around the part by tying.