Section I. INTRODUCTION

TM 11-6130-245-24P-2

SECTION I

INTRODUCTION

Code

1. Scope

Definition

PA- Item procured and stocked for anticipated or

This manual lists spares and repair parts; special

known usage.

tools; special test, measurement, and diagnostic

PD- Support item, excluding support equipment,

equipment (TMDE), and other special support

procured for initial issue or outfitting and

equipment r e q u i r e d for performance of

stocked only for subsequent or additional

organization direct support, ond general support

initial issues or outfittings. Not subject to

maintenance of the PP-2309C/U. It authorizes the

automatic replenishment.

requisitioning and issue of spares and repair parts

PF- Support equipment which will not be stocked

as indicated by the source and maintenance codes.

but which will be centrally procured on

2. General

demand.

MF- Item to be manufactured or fabricated at the

This Repair Parts and Special Tools List is divided

into the following sections

direct support maintenance level.

MH- Item to be manufactured or fabricated at the

a. Section II. Repair Parts List. A list of spares

general support maintenance level.

and repair parts authorized for use in the per-

MD- Item to be manufactured or fabricated at the

formance of maintenance. The list also includes par-

depot maintenance level.

ts which must be removed for replacement of the

XA- Item is not procured or stocked because the

authorized parts. Parts lists are composed of func-

requirements for the item will result in the

tional groups in numeric sequence, with the parts in

replacement of the next higher assembly.

each group listed in figure and item number sequen-

XD- A support item that is not stocked. When

ce.

required, item will be procured through nor-

b. Section III. Special Tools List. Not applicable.

mal supply channels.

c. Section IV. National Stock Number and Part

NOTE

Number Index. A list, in National item iden-

tification number (NIIN) sequence, of all National

Cannibalization or salvage may be used

as a source of supply for any items source

stock numbers (NSN) appearing in the listings,

followed by a list, in alphameric sequence, of all part

coded above except those coded XA and

numbers appearing in the listings. National stock

aircraft support items as restricted by

AR 700-42.

numbers and part numbers are cross-referenced to

(2) Maintenance code. Maintenance codes are

each illustration figure and item number ap

assigned to indicate the levels of maintenance

pearance.

authorized to USE and REPAIR support items. The

3. Explanation of Column

maintenance codes are entered in the third and four-

th positions of the Uniform SMR Code format as

a. Illustration This column is divided as follows:

follows:

(1) Figure number. Indicates the figure number

(a) The maintenance code entered in the third

of the illustration on which the item is shown.

position will indicate the lowest maintenance level

(2) Item number. The number used to identify

authorized to remove, replace, and use the support

item called out in the illustration.

item. The maintenance code entered in the third

b. Source, Maintenance, and Recoverability

position will indicate one of the following levels of

(SMR) codes.

maintenance

(1) Source code. Source codes indicate the man-

Application/Explanation

Code

ner of acquiring support items for maintenance,

repair, or overhaul of end items. Source codes are en-

O- Support item is removed, replaced, used at the

tered in the first and second positions of the

organizational level.

Uniform SMR Code format as follows:

F- Support item is removed, replaced, used at the

direct support level.