TM 9-2330-285-14&P/TO 36A11-21-10-1
HYDRAULIC BRAKE LINES - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
TUBE INSTALLATION - REAR DOLLY
NOTE
This is a typical procedure for the left or the right side
brakes.
For late model dolly sets there is no left side brake tube.
There are two clamps holding the right side tube.
For early model dolly sets there are two clamps on the right
side brake tube. There are no clamps holding the left side
tube.
Step 14 applies only to late models, right side.
a. Position tube (5) on axle beam (1).
12 Axle beam (1)
Clamps (2),
b. Secure with clamps (2), screws (3) and
screws (3) and
washers (4) (if applicable).
washers (4)
Connect using a 7/16-inch wrench.
Tube (5)
13 Master cylinder (6)
14 Wiring harness (7)
Ten wire ties (8)
Secure harness (7) to tube (5) with wire
ties (8).