TM 9-2330-213-14&P
4-36. WHEEL CYLINDER REPLACEMENT (ALL EXCEPT M105A2C).
This Task Covers:
b.
Installation
Removal
a.
Initial Setup:
Materials/Parts:
Equipment Conditions:
4-34).
General mechanic's tool kit
Drain part
NOTE
Chassis model M103A1 has only one wheel cylinder for each service brake
assembly. Chassis model M103A3 has two wheel cylinders for each service brake
assembly. This procedure is typical for all models.
A suitable container should be used to catch any draining brake fluid. Ensure that
all spills are cleaned up.
Remove bolt (1), flatwasher (2), and spacer (4) from connector (3) and wheel cylinder (5).
1.
Remove two screws (8), wheel cylinder (5), and shield (6) from backing plate (7).
2.
b. INSTALLATION
Position shield (6) and wheel cylinder (5) on backing plate (7) and install two screws (8).
1.
Install spacer (4), flatwasher (2), and bolt (1) on connector (3) and wheel cylinder (5).
2.
FOLLOW-ON TASKS:
TA505282