LUBRICATION ORDER AND OIL ANALYSIS

LUBRICATION ORDER

LO 5-6115-614-12

AND OIL ANALYSIS

LI-07536B-12

15 OCTOBER 1986

GENERATOR SET, DIESEL ENGINE

DRIVEN, TACTICAL SKID MTD. 200 KW.

3 PHASE, 4 WIRE, 120/208 AND

240/416 VOLTS

DOD MODEL

CLASS

HERTZ

NSN

MEP009B

UTILITY

50160

6115-01-021-4096

Reference: C1900-IL

directed by a Army Oil Analysis Program (AOAP)

Intervals (on-condition or fixed time) and the related man-

Laboratory which has analyzed the oil for serviceability.

hour time are based on normal operation. The man-hour

time specified is the time needed to do all the services

Clean fittings with an approved solvent before lubricating.

prescribed for a particular interval. On-condition (OC) oil

Dotted lines indicate lubrication points on both sides of

sample interval shall be applied unless changed by the

the equipment, and lubrication points not visible from a

Army Oil Analysis Program (AOAP) Laboratory. Change

top view.

the fixed time Interval if lubricants are contaminated or if

equipment is functioning under adverse operating

Relubricate after washing.

conditions, including longer-than-usual operating hour.

The fixed time interval may be extended during periods of

The lowest level of maintenance authorized to lubricate a

low activity.

It extended adequate preservation

point is indicated by one of the following symbols as

precautions must be taken. Fixed time intervals will be

appropriate:

Operator/Crew (C), and Organizational

applied in the event AOAP laboratory support is not

Maintenance (O).

available.

Drain crankcase when hot. Fill and check level.

On-condition (OC) AOAP Laboratory determined oil

change intervals shall be applied instead of fixed time

Change the engine oil whenever the engine has been in

intervals such as hourly, calendar, or mileage, unless

an overheated condition.

otherwise notified. The services will be required when

CARD 1 OF 2