CHAPTER 5 PACKING FOR SHIPMENT OR STORAGE

TM 11-7021-202-12

CHAPTER 5

PACKING FOR SHIPMENT OR STORAGE

INTRODUCTION

5-1 .

This section provides procedures for packing Data Processing Set AN/UYK-64 (V). Material

used for packing is listed in the Expendable Supplies and Materials List (ESML), appendix

D. Instructions reference each item in the ESML as it is used.

PREPARATION FOR STORAGE OR SHIPMENT

5-2.

Prior to packing the processor for shipment or storage, perform routine Preventive

Maintenance Checks and Services (PMCS). Refer to paragraph 1-4. If the processor is being

forwarded to a higher level of maintenance for repairs, prepare the required equipment

failure report in accordance with paragraph 1-3.

PROCESSOR PACKAGING AND PACKING

5-3.

When packaging and packing the processor for shipment or storage, see figure 5-1 and

perform each of the following steps:

NOTE

Packaging and packing the processor intact is

not recommended. The units power supply

and printed-circuit boards (PCB) should be

removed and packaged and packed in

separate containers. However, disassembly of

the processor is beyond the scope of this

manual.

Install two desiccant bags (item 5, appx E) in a plastic bag (item 6, appx E).

WARNING

The processor is a heavy piece of equipment.

Always use three technicians when moving or

lifting the unit to prevent injury to personnel.

Place the unit in the plastic bag (item 6, appx E).

Place all maintenance forms and tags in the plastic bag with the unit and seal

the plastic bag with tape (item 7, appx E).

5-1