TESTING AFTER REPLACEMENTS OR REPAIRS

TM 11-7021-202-12

NOTE

If at any point in the procedure the processor

fails to operate properly, refer to chapter4,

Section II and perform the required

troubleshooting.

(2) Remove power to the unit by disconnecting the power cable connector from the

power source.

(3) Position the processor into its normal operating location (stand-alone or rack

mounting), and connect I/O cables, connect ground strapping if applicable, and

finally connect the power cable connector to the power source.

(4) Once again, verify a successful BITE self-test.

4-21/(4-22 Blank)