TM 9-2350-222-20-1-5
RIGHT ANGLE DRIVE REPLACEMENT (Sheet 1 of 5)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Cleaning and Inspection
Installation
Large slip joint pliers
TOOLS:
Center punch
1/2 in. combination box and
Hammer
open end wrench
Flat-tip screwdriver
9/16 in. socket with 1/2 in. drive
12 in. extension with 1/2 in. drive
5/16 in. socket head screw key
(allen wrench)
Container (to catch fluid)
Electrician's tape (Item 58,
SUPPLIES:
Gasket (10940613)
Gasket (7383695)
Dry cleaning solvent (Item 54,
Gasket (7383694)
Lockwasher (MS35338-46)
Lockwasher (MS35338-45)
(2 required)
(16 required)
REFERENCE: LO 9-2350-222-12
PRELIMINARY PROCEDURE:
REMOVAL:
NOTE
Using center punch, scribe a
mark on housings to help
aline parts at installation.
1.
Place container under clutch housing (A) and right angle drive (B) to catch fluid.
2.
Using 5/16 inch allen wrench, remove two plugs (C) and allow fluid to drain.
TA253660
Go on to Sheet 2