TM 9-2350-222-20-1-5
DRIVER'S SEAT SUPPORT AND HOUSING ASSEMBLY REPAIR (Sheet 5 of 7)
ASSEMBLY:
1.
Position shaft (A) in adjusting assembly (B) with
pin holes alined.
2.
Using hammer and punch, install pin (C)
through assembly (B) and shaft (A).
3.
Position trip lever (D) in housing (E).
4.
Position adjusting assembly (B) to housing (E).
5.
Install two shafts (F) through housing (E) and
adjusting assembly (B).
6.
Using retaining ring pliers, install four
retaining rings (G) on ends of two shafts (F).
Position shaft of lever (H) through holes in
7.
housing (E) and trip lever with holes alined.
8.
Using hammer, install pin (J) through trip lever
(K) and lever (H).
Go on to Sheet 6