TM 9-2350-222-20-1-5
AMMUNITION RACK HANDLE ASSEMBLY REPAIR AND REPLACEMENT (Sheet 2 of 3)
INSPECTION AND REPAIR:
1.
Inspect pad (A). If damaged, using flat-tip screwdriver and 1/2 inch wrench, remove screw (B) and
nut (C).
2.
Inspect sleeve (D), nut (E), spring (F), handle (G), and pin (H) for damage. Replace items as
necessary.
3.
Using punch and hammer, drive out pin (H) and remove sleeve (D), nut (E), and spring (F).
4.
Install spring (F), nut (E), and sleeve (D) onto handle (G).
5.
Using hammer, install pin (H) through sleeve (D) and handle (G) until pin is flush with surface of
sleeve.
Go on to Sheet 3
TA139212