TM 9-2350-222-20-1-5
DRIVER'S HATCH LATCH (HOLD OPEN) AND STOP REPLACEMENT (Sheet 1 of 2)
TOOLS: Long round nose pliers
3/4 in. combination box and open end wrench
1/8 in. punch
Flat-tip screwdriver
1/2 in. combination box and open end wrench
Hammer
Vise
SUPPLIES: Cotter pins (MS24665-132) (2 required)
REMOVAL:
1.
Using screwdriver and pliers, remove cotter
pins (A). Throw cotter pins away.
Using pliers, remove pin (B) while holding latch
2.
assembly (C).
3.
Remove latch assembly (C) and spring (D) from
hatch (E).
4.
Using punch and hammer, drive pin (F) out of
latch (C). If necessary, use vise.
Using 3/4 inch wrench, loosen nut (G) and,
5.
using 1/2 inch wrench, remove setscrew (H).
6.
Remove nut (G) from setscrew (H).
Go on to Sheet 2
TA140712