TM 9-2815-237-34
2-41. ENGINE ASSEMBLY FROM SUBASSEMBLIES (Cont’d)
27.
28.
29.
30.
31.
32.
Install remaining bearing caps (2) on cylinder block (8) with long capscrews (4) and short
capscrews (5). Tighten capscrews (4) and (5) to 40 lb-ft (54 N•m).
Evenly tighten all long capscrews (4) to 110 lb-ft (149 N•m).
Evenly tighten all short capscrews (5) to 100 lb-ft (136 N•m).
NOTE
Perform steps 30 through 32 for 6.5L engines.
Coat rear crankshaft (7) surface with engine oil, and lightly coat lip of rear main oil seal (9) with
engine oil.
Insttall rear main oil seal (9), with spring Cavity towards cylinder block (8), on crankshaft (7).
Using seal installer, drive rear main oil seal (9) in until tool bottoms against cylinder block (8) and
2-157
|
|
