TM  9-2815-202-34 4-18.   GOVERNOR   AND   BLOWER   ASSEMBLY   REMOVAL/lNSTALLATION This  task  covers: a:  Removal b:  Installation INITIAL    SETUP MODELS EQUIPMENT   CONDITION All Para 4-2 4-10 TOOLS  AND  SPECIAL  TOOLS 4-11 4-12 General mechanics tool kit (App B, Item 96) 4-13 Multiple sling (App B, [tern 83) Torque wrench (App B, Item 101) 4-16 4-17 MANDATORY  REPLACEMENT  PARTS 5-15 1  Gasket  (App  F,ltem  56) 1 Gasket (App F,ltem 65) 5.1-11 2  Copper  washers  (App  F,  Item  164) 6-3 8 Lockwashers  (App  F,  Item  92) 6-11 1 Hose (App F,ltem 84) 2 Hoses (App F, Item 85) a.   Removal Description Turbocharger removed (7083-7395) Air box heater removed (7083-7395 and 7083-7396) Rocker  arm  covers  removed Fuel Dump removed Air  inlet  housing  removed  (Except 7083-73911 Blower drive shaft removed (7083-7395 and 7083-7398) Governor rover and throttle control  rods  removed Blower  drive  shaft  removed  (7083-7391, 7083-7396, and 7083-7399) Air inlet housing removed (7083-7391) Turbocharger removed (7083-7398) Air box heater removed (7083-7398 and 7083-7399) (1) (2) (3) (4) (5) Loosen  four  clamps  (1).  Slide  two hoses (2) up on governor fuel rod tubes (3) clear of cylinder heads. Disconnect oil tube nuts (4 and 5) on tube (6). Slide oil tube into fitting (7). Loosen two clamps (8) on hose assembly  (9). Remove two bolts (10) and flat washers (11) securing blower (12) to engine  block  (13). Remove  six  bolts  (14)  and  retaining clips  (15)  securing  blower  (12)  to engine  block  (13). NOTE When  removing  blower,  lift  blower up  slightly  and  move  blower  forward to detach from hose. (6) Using multiple sling, lift blower (12) up from engine block (13). Remove blower  gasket  (16).  Discard  gasket. 4 - 5 8 Change 1