Figure 2-3. Clutch controls, installed views

TM 5-3655-210-12

1. Transfer pump clutch shifter

3. Refrigeration compressor clutch shifter

2. Cylinder filling compressor clutch shifter

Figure 2-3. Clutch controls, installed views

z. Clutch Shifters. The three clutch shifters are

side of the power compartment. It is a three-

pole, double-throw switch controlling the rotation of the

mounted on the countershaft in the power compartment.

electric motor.

They are manual controls to engage the three clutches

x. Conversion Heater Vibrator Switch.

The

which operate the transfer pump (1, fig.2-3),

vibrator switch (20, fig. 2-5) is located on the ignition

refrigeration compressor (3) and the cylinder filling

unit of the conversion heater. This switch is safety wired

compressor (2).

aa. Governor Controls. The governor control (24,

at the factory. The vibrator is wired with two sets of

contacts. When the normal set of contacts have failed

fig. 2-10) is located on the left side of the gasoline

the wire must be cut to pull the switch out. The vibrator

engine. It controls the speed of the gasoline engine.

is then operating on the reserve contacts.

y. Battery Circuit Breaker. The battery circuit

2-3.

Operation Under Usual Conditions

breaker (3, fig. 2-2) is mounted on the engine control

a. General.

panel and provides overload protection for voltage

Instructions in this section are

sensitive components.

published for the use of the personnel responsible for

the operation of the conversion and storage unit.

2-4