Placing Dolly Half in Maneuvering Position.-continued

MWO 9-2330-390-35-1

APPENDIX B. MANEUVERING POSITION (Con't).

CAUTION

Proceed slowly and with caution to prevent equipment damage.

NOTE

If operating a dolly half equipped with side lift kit, extension of lift and positioning

cylinders should stop when top beam vertical tubes have extended approximately 49

in. (124 cm) and positioning cylinder limit lines are just visible.

(4)

Pull down on two lift cylinder levers (56) to extend lift cylinders (73) and positioning

cylinders (2). Stop when near (left side) top beam vertical tube (58) reaches within ½ in.

(13 mm) of hydraulic control valve (74) and fittings (90).

(5)

Continue to pull down on two lift cylinder levers (56), allowing near (left side) lift

cylinder (73) to lead far (right side) lift cylinder. Maintain clearance of 1/8 in. (13 mm).

(6)

If operating a dolly half equipped with side lift kit, return positioning cylinders lever

(71) to NEUTRAL position.

(7)

Continue to pull down on two lift cylinder levers (56) until bottom beam (3) is raised off

the ground and axle (42) and pivoting tray (65) are parallel to the ground. Dolly half is

now in maneuvering position.

WARNING

While in maneuvering position, DO NOT operate positioning cylinders lever. Failure

to follow this warning may cause bottom beam to lower to the ground, causing

serious injury to personnel.

(8)

Return positioning cylinders lever (71) to NEUTRAL position, as required.

B-2