TM 10-5411-224-14
5-6. REPAIR OF SHELTER PANEL DENT - continued.
NOTE
Make sure that the area is completely clean. Do not touch the area with hands or any item that
may leave an oily residue.
2. Wear rubber gloves and use a clean cotton cloth with alcohol and clean the entire surface.
3. Fill the dent with body filler using a putty knife or other flat-edge implement and smooth the surface evenly
to a feathered edge.
4. Allow the resin to set thoroughly (approximately 1 hour depending on ambient air temperature) in
accordance with manufacturers recommendations.
5. Sand the repaired area to a flat, smooth finish.
6. Prime and paint the repaired surface in accordance with paragraph 3-7.
Figure 5-8. Repair of Shelter Panel Dent
5-15