TM 9-2320-269-10
AUTOMATIC TRANSMISSION RANGE SELECTOR
Key
Control or Indicator
Function/Use
NOTE
There is no PARK position in the transmission. Always supply parking brake to hold vehicle when there Is
no one in it. Make sure the shift selector is in NEUTRAL position.
3
RANGE (SHIFT) SELECTOR -
Moving range selector to any position shown on the shift pattern plate
(Shown in NEUTRAL
places the transmission into selected drive range. Transmission must
position)
always be in "NEUTRAL" position when operating hydraulic driven
equipment, such as winches, and derrick.
4
DRIVE 2-5 RANGE
Used for normal loads, grades, and traffic conditions, with open road
ahead.
DRIVE 2-4 RANGE
Used for moderate grades, and over the road operation with restrictive
speeds.
DRIVE 2-3 RANGE
Used for heavy traffic conditions.
DRIVE 1 RANGE
Used for low gear hold condition when going up or going down steep
grades that require engine brake ability, or operation in rough terrain.
5
REVERSE RANGE
Used to move vehicle backwards. Allow engine to idle before shifting
in reverse, then move selector into reverse.
TA 222524
2-15