18-3. M1090/M1094 PINTLE HOOK EXTENSION KIT INITIAL INSTALLATION CONT.

TM 9-2320-366-34-4 a. Installation. NOTE The kit is installed the same on M1090 and M1094. M1094 shown. (1) Remove cotter pin (1) from nut (2). Discard cotter pin. (2) Remove nut (2) and washer (3) from pintle hook (4). WARNING Pintle hook weighs approximately 65 lbs (30 kgs). Attach a suitable lifting device prior to removal. Failure to comply may result in injury to personnel or damage to equipment. (3) Remove pintle hook (4) from rear crossmember (5). (4) Remove four self-locking nuts (6), bolts (7), and support (8) from rear crossmember (5). Discard self-locking nuts. NOTE • Left and right clamps are removed the same way. Right side shown. • Remove plastic cable ties as required. (5) Remove self-locking nut (9), screw (10), and clamp (11) from L-bracket (12). Change 1 18-21