|
| |
Back
3-2. COMPRESSION TESTING | Up
/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual | Next
3-3. ENGINE AND ENGINE MOUNT REMOVAL (Con’t) |
TM 9-2320-289-34
3-3. ENGINE AND ENGINE MOUNT REMOVAL.
This task covers:
a. Removal
INITIAL SETUP:
Equipment Condition
Hood removed (if removing engine). (See TM 9-2320-289-20)
Radiator and radiator hoses removed (if removing engine). (See TM 9-2320-289-20)
Vacuum modulator pipe removed (if removing engine). (See paragraph 5-3)
Engine coolant heater hoses removed (if removing engine equipped with winterization kits).
(See TM 9-2320-289-20)
Air conditioner compressor removed from brackets and tied aside (if removing Ml010
engine). (See paragraph 10-24)
Power steering pump dismounted from engine (if removing engine). (See TM 9-2320-289-20)
Engine
oil
cooler
lines
disconnected
from
engine
(if
removing
engine).
(See
TM 9-2320-289-20)
Engine coolant heater front exhaust pipe and heat exchange pipe disconnected from engine
oil pan (if removing engine equipped with winterization kits). (See TM 9-2320-289-20)
Engine wiring harness disconnected from engine (if removing engine). (See paragraph 4-10)
Personnel Required
l MOS 63W (2)
NOTE
If only removing engine mount
or engine
mount brackets,
perform steps 5-8.
A suitable container should be
u s e d to
c a t c h f u e l f r om
disconnected fuel lines (1 and
3).
Ensure that all hoses, Pipes,
a n d l e a d s a r e t a g g e d f or
installation.
1.Disconnect fuel line (3) from fuel
pump (2) and fuel return hose (1).
TA60616
3 - 3
|
