Table 2-5. Organizational Troubleshooting (cont).

TM 5-3610-286-20 Table 2-5. Organizational Troubleshooting (cont). Malfunction Test or inspection Corrective action 12. IMPRESSION CYLINDER DOES NOT GRIP PAPER PROPERLY (cont). Step 2. Check for proper adjustment of grippers and adjust if required (para. 2-70). Replace gripper pads (para. 2-70). Step 3. Check front lay alignment (TM 5-3610-286-10). Step 4. Inspect ranger drum, head strap, grippers and gripper bar. Adjust and repair as needed (para. 2-67). 13. PRINTING PRESS DOES NOT PRINT WHEN IMPRESSION ON/FEEDER ON PUSHBUTTON (b70) IS PRESSED. l l l WARNING HIGH VOLTAGE Do not operate printing press until you are sure TSS Press Section is connected to a suitable ground. Failure to do so may result in death or serious injury. Shut off power source before attempting to disconnect, service or con- nect wires or cables. Failure do so may result in death or serious injury. When working on high-voltage components, always have an additional person present, and keep one hand away from equipment to reduce hazard of current flowing through vital organs of body. Remove all jewelry from fingers, wrists, and neck prior to working on electrical components. Failure to do so may result in death or serious burns. NOTE The following procedure is the same for the PRODUCTION pushbutton (b71). The only difference is at steps 5 and 8 at which point perform the function using the PRODUCTION pushbutton (b71). Step 1. Check for paper at front lay. If no paper, check feeder. If paper is found at front lay, go to step 2. 2-38