Table 2-5. Organizational Troubleshooting (cont).

TM 5-3610-286-20 Table 2-5. Organizational Troubleshooting (cont). Malfunction Test or inspection Corrective action 7. FEEDER WILL NOT OPERATE WHEN FEEDER ON PUSHBUTTON IS PRESSED (cont). Step 7. Step 8. Step 9. Using a multimeter set to ohms range, check for continuity between points listed below for each component. Relay (d20): Point 43 and Point 44 Relay (d4): Point 13 and Point 14 Contactor (c1): Point 13 and Point 14 Relay (d13): Point 81 and Point 82 If continuity is present, replace faulty component (para. 2-93). If no continuity is present, go to step 8. Using a multimeter set to ohms range, check for continuity between points listed below for each switch. Feeder Stop pushbutton (b83): At wire junction Point E17 and Point E18. Microswitch (b82): Point 29 and Point 143. If continuity is present, replace faulty switch (para. 2-89). If no continuity is present, go to step 9. Check wiring using schematic (figure FO-1). Repair/replace wiring as required. 8. FEEDER BOARD MOVES UP, BUT SHEETS WILL NOT FEED FORWARD WARNING HIGH VOLTAGE l l Do not operate printing press until you are sure TSS Press Section is connected to a suitable ground. Failure to do so may result in death or serious injury. Shut off power source before attempting to disconnect, service, or con- nect wires or cables. Failure to do so may result in death or serious injury. 2-34