Table 2-5. Organizational Troubleshooting (cont)

TM 5-3610-286-20 Table 2-5. Organizational Troubleshooting (cont). Malfunction Test or inspection Corrective action 4. FEEDER BOARD DOES NOT RAISE INTO POSITION (cont). NOTE Step 7 requires one person to depress main pileup pushbutton during performance. Step 7. Using a multimeter set to range higher than 115V ac, check for 115V ac between the points listed below for each component. Contactor c5: Point A1 and Point A2 Relay d227: Point 13 and Point 14 Contactor c6: Point 21 and Point 22 Contactor c5a: Point 13 and Point 14 Relay d103: Point 21 and Point 22 Relay d107: Point 71 and Point 72 If no voltage is observed, replace the faulty component (para. 2-93). If voltage is observed, replace pile lift motor (para. 2-90). NOTE Use same procedure for auxiliary pile motor circuit. Refer to figure FO-1 for associated components and test points. 5. FEEDER BOARD DOES NOT LOWER INTO POSITION. WARNING HIGH VOLTAGE Do not operate printing press until you are sure TSS Press Section is connected to a suitable ground. Failure to do so may result in death or serious injury. Shut off power source before attempting to disconnect, service, or connect wires or cables. Failure to do so may result in death or serious injury. 2-28