Section XIV. MAINTENANCE OF FIXED FLOORS, WALLS AND CEILING

TM 10-5410-223-14/1

(2) Install inserts (11), if removed.

c. Inspection.

(3) Install the plug assembly (19) and secure

(1) Inspect all parts for wear and damage.

with spacers (9), plates (8) and thumbscrews (17).

(2) Inspect the panel for dents, breaks, cracks

(4) Install strips (6) and secure with rivets

and holes.

(5).

d. Repair.

(5) Install nuts (4) and snap fasteners (3).

(1) Replace all worn and damaged parts.

(6) Install the plate assembly handles (2) and

(2) Repair the damaged panels using the ap-

secure with rivets (1).

propriate repair procedure given at the beginning of

f. Installation.

this section.

(1) Install the end panel, figure 4-23, and se-

e. Assembly.

cure with washers and screws.

(1) Install the closeouts (16 and 17, fig. 4-24)

(2) Follow the same procedure, as above, when

and gasket (15), seal (14) and strip (13) onto the

installing the side panel.

raw panel (18) and secure with rivets (12).

Section XIV. MAINTENANCE OF FIXED FLOORS, WALLS AND CEILING

b. Repair. Repair honeycomb damage using

a. Inspection. Inspect the fixed floors, walls and

those procedures listed in Section VIII of this

ceiling for cracks, breaks, dents and holes.

chapter.

Section XV. MAINTENANCE OF LEVLING JACKS AND POLE SUPPORT

(2) Remove the bolts from the lower bracket

4-23.1 Jack Assemblies.

and remove the jack assembly.

The shelter has four jacks. There are two dif-

c. Disassembly.

ferent configurations available. For maintenance of

jacks installed on shelter seial number 1 through

(1) Remove the pin (1, fig. 4-26) and remove

727, refer to paragraph 4-24; for shelter serial num-

the stud (2), washer (3) and seal (4) from the re-

ber 728 and subsequent, refer to paragraph 4-24,1.

tracting tube (14).

The two configurations are completely inter-

(2) Disconnect the wire rope (5) and remove

changeable.

the ratchet (6) from the retracting tube.

(3) Remove the screw (7) and remove wire

4-24. Jack Assemblies (Shelter Serial No. 1

rope (8).

through 727).

(4) Remove the screw (9) and plug (10).

a. General. This paragraph provides mainte-

nance instructions for jacks installed on shelter

(5) Remove the grommet (11), if replacement

serial numbers 1 through 727.

is required.

b. Removal.

(6) Remove the cotter pin (12) and pin (13)

and remove the retracting tube (14) from the plate

(1) Refer to figure 4-25 and remove the cotter

(17).

pin and pin securing the upper portion of the jack

assembly.

(7) Remove the screw (15) and remove the pin

assembly (16) from the plate (17).

4-75

Change 2