Section V. TROUBLESHOOTING

TM 10-5410-223-14/1

Section V. TROUBLESHOOTING

tions that may occur or all tests or inspections and

4-13. General

corrective actions. If a malfunction is not listed

a. This section contains troubleshooting or

(except when malfunction and cause are obvious) or

malfunction information and tests for locating and

is not corrected by listed corrective actions, you

correcting most of the troubles which may develop in

should notify direct support maintenance.

the multipurpose shelter. Each malfunction or

trouble symptom for an individual component or

4-14. Organizational Maintenance Troubleshooting

unit is followed by a list of tests or inspections

Table 4-2 lists the common malfunctions that you

necessary for you to determine probable causes and

may find during the operation or maintenance of the

suggested corrective actions for you to remedy the

multipurpose shelter or its components. You should

malfunction.

perform the tests/inspections and corrective actions

b. This manual cannot list all possible malfunc-

in the order listed.

Table 4-2. Troubleshooting

Malfunction

Test or Inspection

Corrective Action

1. WATER LEAKAGE INTO MULTIPURPOSE SHELTER

Check for damaged, loose, or improperly positioned weather seal assemblies.

Replace damaged or improperly positioned weather seal assemblies as follows:

Refer to paragraph 4-19 and remove rivets (1, fig. 4-8, sheet 1 of 3), retaining strips (2), and seals (3 and

4).

Remove rivets (5, fig. 4-8, sheet 2 of 3), strips (6) and seals (7).

Remove bolts (8, fig. 4-8, sheet 3 of 3), washers (9), and drain cap assembly (10).

Disassemble drain cap assembly by removing rivets (11) and freeing caps (12) and spacers (13, 14, and

15).

Remove seals (16).

Remove rivets (17 and 20), retaining straps (18 and 21), and seals (19 and 22). Remove rivets (23), plate

(24), and seal (25).

4-37