TM 10-5411-236-13&P
OPERATOR MAINTENANCE
AUTHORIZED STOCKAGE LIST MOBILITY SYSTEM (ASLMS)
MODEL NUMBER FPU-8/12 PARTS (OD) P/N 15005002-001
MODEL NUMBER FPU-8/12 PARTS (DS) P/N 15005002-002
MODEL NUMBER FPU-8/12 BULK (OD) P/N 15005001-001
MODEL NUMBER FPU-8/12 BULK (DS) P/N 15005001-002
CLEANING, LUBRICATING AND SPOT PAINTING
INITIAL SETUP:
Material/Parts
References
TM 43-0139; TB 43-0242, WP 0013 00,
Water
Equipment Condition
ASLMS set-up.
Personnel Required
One
Tools
CLEANING AND LUBRICATING
Cleaning and Lubricating of the FPU is performed to keep the FPU and its associated equipment in good
operating condition. The cleaning and lubrication of the FPU can be conducted along with the Preventive
Maintenance Checks and Services (PMCS) procedures described in WP 0016 00. Specific areas
described below need to be cleaned after an operational event or periodically if stored/staged outside of a
fixed facility to keep the container, modules, and accessories performing as designed. Cleaning also
assists in maintaining the condition of the materiel stored within the system. Any damage discovered
when cleaning and/or lubricating that cannot be corrected using the troubleshooting procedures described
in WP 0013 00 should be reported for corrective maintenance.
SPOT PAINTING (CARC) OR POLYURETHANE
In conjunction with PMCS, spot painting of minor scraps and scratches that penetrate the CARC (exterior
and interior walls, doors and floor) or the polyurethane painted surfaces (interior components) will be
operator maintenance. Operator should refer to TM 43-0139, "Painting Instructions for Army Materiel"
and TB 43-0242, "CARC Spot Painting", for instructions on preparing the surface, paint preparation and
safety and health precautions. Expendable items for spot painting are listed in WP 0105 00.
0017 00-1