TB 9-4940-321-30
Section I. INTRODUCTION
1.
General
CAUTION
a. The instructions contained in this bulletin are in
three sections. Section I contains the introduction,
Special care should be exercised to
warnings and cautions, and general instructions. Section
avoid
damage
to
electrical
II is a
guide for installation of
machine shop equipment
connectors, wiring, or electrical
equipment.
installation of machine shop equipment (NSN 4940-00-
To preserve waterproof characteristics,
209-6238) in one ISO-2-1 shelter, unit 2 (NSN 5411-
precautions should be taken not to
holes in walls or floor of shop. Coat
b. Slight variations to installation instructions may
underside of vehicle body with coating
be made at the discretion of the officer in charge.
compound (UNDERCOATING TT-C-
520, NSN 803000-221-1834) where
c. Complete list of items contained in this shop is
mounting hardware projects through
found in SC 4940-95-CLA62.
floor.
d. Personnel performing this installation should
Unit 2, ISO-2-1 shelter, must be level
prior to expanding the sides.
The
expanded portion of the shelter must be
e. Items not mentioned in this bulletin, that may be
level to allow wall, roof, and floor locks to
components of this shop, may be stowed in cabinets and
engage. No equipment will be moved
drawers or secured in such a manner as to avoid
onto expanded floor until shelter is level.
damage in transit.
3.
Location of Equipment
f. All dimensions, fastener sizes, and hardware
sizes are in inches.
a. Location of equipment to be installed or stowed
in the 280 shelter is referenced in figures 2 thru 21 and
g. When entering shop, curbside is at right and
roadside is at left.
(1) Refer
to table 1 for hardware required for
h. Level ISO-2-1 shelter before expanding sides.
installation.
(2) Refer
2.
Warnings and Cautions
mounted.
(3) Refer
to table 5 for electrical components
WARNING
to be mounted.
All electrically powered tools and
(4) Refer
equipment must be grounded prior to
fabricated.
use.
1