ABBREVIATION WORD OR PHRASE A /A ACCOM ALUM. AMS ASSY AUTO. BX CAT CCW CHAR CL CM CN C/O CONTR CROSS-SECT. CU CW DBL DEG DEPT DIA DIM. DOC. DWG EMER EQPT FEAT FED. FIIG FT GND GOVT GPM H IAW IDENT IN. INCL INSP KVA LG MATL MIL MIN MM MTG ANY ACCEPTABLE ACCOMMODATION ALUMINUM AERONAUTICAL MATERIAL SPECIFICATION ASSEMBLY AUTOMATIC BOX CATALOG COUNTERCLOCKWISE CHARACTERISTICS CLASS CENTIMETER(S) CAN CONSISTS OF CONTRACT CROSS-SECTION CUBIC CLOCKWISE DOUBLE DEGREE(S) DEPARTMENT DIAMETER DIMENSIONS DOCUMENT DRAWING EMERGENCY EQUIPMENT PEATURES FEDERAL FEDERAL ITEM IDENTIFI- CATION  GUIDE FEET GROUND, GROUNDING GOVERNMENT GALLONS  PER  MINUTE HEIGHT, HIGH HYDRAULIC IN ACCORDANCE WITH IDENTIFICATION INCHES INCLUDES,  INCLUDED, INCLUDING,  INCLUSIVE INSPECTION,  INSPECTOR KILOVOLT  AMPERE LENGTH MATERIAL MAXIMUM MILITARY MINIMUM MILLIMETER MOUNTING ABBREVIATION WORD OR PHRASE N/ NSN NAT N/INCL NO. NOM O/A ORD OZ PC PCB PKG P/N PROM PRESS. PSI PT NO PWR QTY RD RDG REF RES REV RPM SER SPEC STD STK SUP. SURF. THD THK TREAT. HYD V VDC VEH W W / W/O YD NOTE: NOT NATIONAL  STOCK NUMBER NATURAL NOT  INCLUDED NUMBER NOMINAL OVERALL ORDNANCE OUNCE(S) PRINTED  CIRCUIT PRINTED  CIRCUIT BOARD PACKAGE(D) PART  NUMBER PLUS OR MINUS PRESSURE POUNDS PER SQUARE INCH PART  NUMBER POWER QUANTITY ROUND REFERENCE  DRAWING GROUP REFERENCE RESISTANT REVOLUTION REVOLUTIONS  PER MINUTE SERIAL SPECIFICATION(S) STANDARD STOCK SUPPLY SURFACE THREAD(S)(ED) THICKNESS) TREATED,  TREATMENT VOLT(S) VOLT  DIRECT  CURRENT VEHICLE WIDTH, WIDE WITH WITHOUT YARD The   Religious   Program   Specialist   should   con- sult   the   personnel   in   the   supply   department MAX whenever  the  Identification  List  (IL)  is  utilized to  ensure  that  a  proper  interpretation  is  made when  supplies  are  ordered.  This  is  especially important   when   ecclesiastical   supplies   are ordered  in  support  of  the  CRP. Figure II-2-5.—Abbreviatios and Symbols Used in the Identification List (IL) and Their Meanings. 2-8