Chapter 2. SERVICE UPON RECEIPT AND INSTALLATION

TM 11-5825-270-23

CHAPTER 2

SERVICE UPON RECEIPT AND INSTALLATION

2-1. Unpacking

adjustments of the monitor receiver are listed in

table 2-1.

The monitor receiver is packed in a cardboard box;

Table 2-1. Tools and Test Equipment Required

unpacking of the monitor receiver is straightforward and

does not require any special instructions.

Item

Common Name

2-2. Checking Unpacked Equipment

Electronic Counter Mainframe

Frequency Counter

TD-1209/U

a. Inspect the Monitor receiver for damage which

Multimeter AN/USM-223

Multimeter

may have occurred during shipment. If monitor receiver

Tool Kit, Electronic Equipment

Toolkit

has been damaged, report the damage on SF 361.

TK-105/G

b. Check the monitor receiver against the

Oscilloscope OS-261/U

Oscilloscope

components of end item list (COEIL) in the Operator's

Manual (TM 11-5825-270-10) and the packing slip to see

b. Adjustment Procedures. Refer to figure 2-1 and

if the equipment is complete. Report all discrepancies in

proceed as follows:

accordance with paragraph 1-3. The monitor receiver

should be placed in service even though a minor

assembly or part that does not effect proper functioning

is missing.

c. Check to see whether the monitor receiver has

been modified (equipment which has been modified will

have the MWO number on the front panel near the

nomenclature plate). Check also to see whether all

applicable MWO's have been applied (current MWO's

applicable to the equipment are listed in DA PAM 310-4

as applicable).

2-3. Installation Instructions

Installation of the monitor receiver will be accomplished

by a special installation team.

2-4. Post-Installation Adjustments

(Figure 2-1 Sheet 1 of 4)

(Figure 2-1 Sheet 2 of 4)

NOTE

(Figure 2-1 Sheet 3 of 4)

The following adjustments must be

(Figure 2-1 Sheet 4 of 4)

made at the time of initial installation

or whenever the monitor receiver or

its assemblies are replaced.

Figure 2-1 (1). Identification of Adjustments/Controls

a. Tools and Test Equipment Required The tools

(Sheet 1 of 4).

and test equipment required for post-installation

2-1