Special information

h. Quantity Incorporated in Unit. Indicates the quantity of the item used in the breakout shown on the

illustration figure, which is prepared for functional group, subfunctional group, or an assembly. A "V"

appearing in this column in lieu of quantity indicates that no specific quantity is applicable (e.g., shims,

spacers, etc).

4. Special information

a. Repair parts for components of standards sets which can be identified as existing in the supply

system will be requisitioned through normal supply channels from the appropriate supply commodity

manager.

b. Repair parts for components of standards sets which cannot be identified as to proper supply

source will be requisitioned from USAMICOM, using routing identifier B64 and furnishing as a minimum, the

following as exception data.

(1) Component stock number of the individual end item to be repaired.

(2) Component manufacturer's equipment model number and serial number.

(3) The equipment manufacturer's stock number as listed in the appropriate manual for the

desired repair part.

(4) The repair part reference designation, circuit reference, circuit symbol schematic

designation, or reference number as listed in the manufacturer's manual.

(5) The technical specification of the repair part as contained in the appropriate

manufacturer's manual.

(6) The title and date of the manufacturer's manual from which the information in paragraphs

a, b(3), (4), and (5) above was taken.

NOTE

Repair parts should not be requisitioned for plug-in boards identified in the plug-in boards identified in the

plug-in board exchange program, except by the depot designated to perform the repair. Repair of

calibration set components, with plug-in board assemblies or subassemblies designated as program

exchange replacements with a recoverability code of L, will be accomplished by replacing the plug-in board.

c. The plug-in board exchange program functions are as follows:

(1) Requisitioning instructions for initial issue plug-in boards will be provided since new

instrument boards are included in the program.

(2) As a plug-in board covered by the program fails, a replacement will be requisitioned.

Requisitions will be submitted to Commander, US Army Missile Command, B64, Redstone Arsenal,

AL 35809.

(3) Simultaneously with c(2) above, the defective board being replaced will be shipped by

certified mail, return receipt requested, to the following address:

Transportation Officer

Anniston Army Depot

M/F Field Service Stock

Anniston, AL 36201

When requisitioning a replacement board, the turn-in document number of the replaced board shall be cited

on requisition.

5. How to Locate Repair Parts

a. When NSN or reference number is unknown:

(1) First. Using the table of contents, determine the assembly (functional group) within

which the repair part belongs.