Appendix C. MAINTENANCE ALLOCATION CHART

9-6115-652-14&P

APPENDIX

MAINTENANCE

ALLOCATION

CHART

Section

INTRODUCTION

C-1. G e n e r a l .

a. This section provides a general explanation of all maintenance and repair functions authorized at various

maintenance

levels.

b. Section II designates overall responsibility for the performance of maintenance functions on the identified

end item or component. The implementation of the maintenance functions upon the end item or component will

be consistent with the assigned maintenance functions.

c. Section IIl lists the tools and test equipment required for each maintenance function as referenced from

d. Section IV contains supplemental instructions, explanatory notes and/or illustrations required for a particular

maintenance

function.

C-2. Explanation

Columns

Section

II.

a. G r o u p N u m b e r . C o l u m n 1 . The assembly group is a numerical group assigned to each assembly in a top

d o w n breakdown sequence. The applicable assembly groups are listed on the MAC in disassembly sequence

beginning with the first assembly removed in a top down disassembly sequence.

2 . This column contains a brief description of the components of each assembly

b. A s s e m b l y G r o u p . C o l u m n

group.

c. M a i n t e n a n c e F u n c t i o n s . C o l u m n 3 . This column lists the various maintenance functions (A through K) and

indicates the lowest maintenance category authorized to perform these functions. The symbol designations for

the various maintenance categories are as follows:

Operator or crew

Unit

maintenance

Direct support maintenance

General

support

maintenance

Depot maintenance

The maintenance functions are defined as follows:

A - Inspect. To determine serviceability of an item by comparing its physical, mechanical, and electrical

c h a r a c t e r i s t i c s with established standards.

B - Best. To verify serviceability and to detect electrical or mechanical failure by use of test equipment.

C-1